![]() ![]() Set Up Carl Bot To Your Discord Server Today.User Engagement And Interaction Commands:.#3- Robust Moderation Through Automod That Works Even When Offline.#2- Logging Chats And Everything At Once.Discord- a Social Platform Perfect for Community Building.To log in to a target during boot, enable rvice and make sure the nodes have node.startup = automatic in their configuration ( /etc/iscsi/nodes/iqn. You can also check where the attached iSCSI devices are located in the /dev/ tree with: Tips and tricks Check for attached iSCSI devices If you use multipath, you also have to rescan multipath volume information.Rescan active nodes in current session # iscsiadm -m node -R.In this case you have to unmount the filesystem and alter the size of the affected partition. If the iscsi blockdevice contains a partitiontable, you will not be able to do an online resize. The last line of the above command will show the name of the attached device e.g # iscsiadm -m node -targetname= targetname -login Login to available targets # iscsiadm -m node -L all On success information about nodes and target will be saved on your initiator.Īdd target manually # iscsiadm -m node -target targetname -portal target_ip -o newĪ possible scenario to use this is when server does not allow discovery.ĭelete obsolete targets # iscsiadm -m discovery -p target_ip -o delete # iscsiadm -mode discovery -portal target_ip -type sendtargets node-name/ node-ip-address, port,1/default and add/adjust the options as necessary. To update them, edit /etc/iscsi/nodes/iqn. Note: The authentication data is saved in per-node configuration files. If your target requires authentication to get the list of its nodes (most will not) then following lines should be edited:ĭ = CHAPĭ = initiators_usernameĭ = initiators_passwordĭ_in = targets_usernameĭ_in = targets_password If your target has two-way authentication enabled then those lines also need to be edited: The following parameters are used for authenticating a login session of an initiator to a target: If the ISCSI target requires authentication by the initiator, the configuration file /etc/iscsi/nf may need to be updated. If you wish to generate new IQN the iscsi-iname utility can be used which prints out new IQN. Open-ISCSI stores its initiator IQN in the /etc/iscsi/initiatorname.iscsi file with a format InitiatorName= iqnĭuring installation the initial IQN will be generated. IQN is used for identifying every device. Node directory /etc/iscsi/nodes which has directories named after IQN (ISCSI Unique Name) of particular device.Discovery directory /etc/iscsi/send_targets which has directories named after target addresses.Persistent configuration is implemented as a tree of files and directories, which are contained in two directories: | kernel modules: scsi_transport_iscsi, iscsi_tcp, libiscsi | | sessions and targets | | and iscsi kernel modules | | * Manages database of | | * Communicates with iscsiadm | | * Command line tool || * Implements Session management | | Targets & Sessions configuration files and directories | A more detailed version can be found here: Open-iSCSI modules (Outdated) +-+ The following diagram shows how the Components work together. This should not be confused with, the website for the LIO target. Note: An older initiator, Linux-iSCSI, was merged with Open-iSCSI in April 2005. ![]()
0 Comments
Leave a Reply. |